Plasma and Fusion Research

Volume 13, 3502100 (2018)

Overview Articles

Recent Activities on SST-1 and ADITYA-U Tokamaks
Promod K. SHARMA1,2), Yogesh M. JAIN1,2), Kiran K. AMBULKAR1), Pramod R. PARMAR1), Chetan G. VIRANI1), Saifali DALAKOTI1), Jagabandhu KUMAR1), Arvind L. THAKUR1), Daniel RAJU1,2), Joydeep GHOSH1,2) and SST-1 and ADITYA-U Team1)
1)
Institute for Plasma Research, Bhat, Gandhinagar - 382428, Gujarat, India
2)
Homi Bhabha National Institute, Mumbai, Maharashtra, India
(Received 12 January 2018 / Accepted 12 April 2018 / Published 10 August 2018)

Abstract

The successful operation of superconducting tokamaks is very challenging because of limitations arising out of a complex geometry, configuration and construction. The slow penetration of loop voltage because a continuous plasma chamber requires low loop voltage plasma initiation. Apart from these operational challenges, SST1 also has technical issues related to cooling down of the superconducting poloidal field (PF) coils, for obtaining advanced plasma operation and control. Furthermore, limits are imposed on the loop voltage by magnet power supplies and PF coil insulation. To improve our understanding of these issues, operations in SST-1 have been attempted with low loop voltages and will be discussed in this paper.
It is envisaged that designing and carrying out experiments in SST1, to understand above issues, may be very complex, time consuming and may not be feasible due to complexities in SST1 machine operational scenario. Hence Aditya machine upgradation was initiated with the understanding that solution to some of these problems may be obtained through experiments specially designed for this purpose in ADITYA-U, in parallel. Thus some of these experiments are also being planned to carry out in tokamak ADITYA-U, in particular, non-inductive current drive using lower hybrid waves, employing passive active multi-junction (PAM) antenna. The performance of the lower hybrid waves launched by the grill antenna is presented and the need for PAM antenna is presented. The design of the PAM antenna for ADITYA-U machine is also discussed.

Keywords

tokamak, SST1, ADITYA-Upgrade, lower hybrid current drive

DOI: 10.1585/pfr.13.3502100

Full Text

PDF format (2.7Mbytes) PDF Download

References

  • [1] D. Van Houtte and Equipe TORE SUPRA, Nucl. Fusion 33, 137 (1993).
  • [2] Y.C. Saxena and SST1 Team, Nucl. Fusion 40(6), 1069 (2000).
  • [3] B. Wan and International Collaborators, Nucl. Fusion 40, 1057 (2000).
  • [4] H.L. Yang et al., Fusion Eng. Des. 86, 588 (2011).
  • [5] F.W. Perkins, D.E. Post, N.A. Uckan, M. Azumi et al., Nucl. Fusion 39, 2137 (1999).
  • [6] D. Bora, P.K. Sharma, S.L. Rao, R.G. Trivedi et al., Fusion Eng. Des. 82, 141 (2007).
  • [7] P.K. Sharma, Fusion Sci. Technol. 65, 103 (2014).
  • [8] F. Jobes, J. Stevens, R. Bell, S. Bernabei et al., Phy. Rev. Lett. 52(12), 1005 (1984).
  • [9] M. Seki and R. Yoshino, Plasma Phys. Control. Fusion 39, 205 (1997).
  • [10] H.P. Summers, “Atomic data and analysis structure”, JET, Report No. JET-IR(94)-06 (1994).
  • [11] S.B. Bhatt, D. Bora, B.N. Buch, C.N. Gupta et al., Indian J. Pure Appl. Phys. 27, 710 (1989).
  • [12] P.K. Sharma, S.L. Rao, D. Bora, R.G. Trivedi et al., Fusion Eng. Des. 82, 41 (2007).
  • [13] F. Mirizzi, Ph. Bibet, A.A. Tuccillo et al., Proc. of the 22nd SOFT, 9-13 Sept., Helsinki, Finland (2002).
  • [14] A. Ekedahl, L. Delpech, M. Goniche, D. Guilhem et al., Nucl. Fusion 50, 112002 (2010).
  • [15] Y.M. Jain and P.K. Sharma, 32nd National Symposium on Plasma Science and Technology (Plasma-2017), 07-10, Nov., Gandhinagar, India (2017).