Plasma and Fusion Research

Volume 13, 3405057 (2018)

Regular Articles

Operations of the Helium Subcooling System for the LHD Helical Coils during Ten Plasma Experimental Campaigns
Shinji HAMAGUCHI, Shinsaku IMAGAWA, Tetsuhiro OBANA, Nagato YANAGI and Toshiyuki MITO
National Institute for Fusion Science, Toki 509-5292, Japan
(Received 29 December 2017 / Accepted 22 March 2018 / Published 10 May 2018)

Abstract

The Large Helical Device has a helium subcooling system with two cold compressors for helical coils to enhance the magnetic fields and improve the cryogenic stability of the coils by lowering the coil temperature. The system was installed in 2006 and then it has stably supplied 3.2 K subcooled helium at the nominal mass flow rate of 50 g/s to the coils during ten plasma experimental campaigns. The running time of the cold compressors exceeds 30,000 hours and the total time of subcooling operations exceeds 20,000 hours. In the system, the supplied helium is subcooled in a heat exchanger of a saturated helium bath. The bath pressure and temperature are reduced by a series of two centrifugal cold compressors with gas foil bearing. In the steady state subcooling operation, the bath temperature is stabilized within range of 0.02 K with automatic flow control of helium gas through the cold compressors by a heater in the bath. The control method is also useful to protect the system by mitigating large disturbance of the pressure and the mass flow rate. In the present study, the thermal hydraulic behavior of the system and the operational performance during ten plasma experimental campaigns are reported.

Keywords

cold compressor, subcooled helium, superconducting coil, cooling system, automatic control

DOI: 10.1585/pfr.13.3405057

Full Text

PDF format (1.3Mbytes) PDF Download

References

  • [1] A. Iiyoshi et al., Nucl. Fusion 39, 1245 (1999).
  • [2] O. Motojima et al., J. Plasma Fusion Res. 5, 22 (2003).
  • [3] S. Imagawa et al., Fusion Eng. Des. 81, 2583 (2006).
  • [4] S. Hamaguchi et al., IEEE Trans. Appl. Supercond. 14, 1439 (2004).
  • [5] S. Caspi, Adv. Cryog. Eng. 29, 281 (1984).
  • [6] A. Sakurai et al., Adv. Cryog. Eng. 35, 377 (1990).
  • [7] S. Hamaguchi et al., Adv. Cryog. Eng. 53, 1724 (2008).
  • [8] S. Imagawa et al., IEEE Trans. Appl. Supercond. 18, 455 (2008).
  • [9] S. Hamaguchi et al., Fusion Sci. Technol. 58, 581 (2010).
  • [10] G. Claudet et al., Fusion Eng. Des. 58-59, 205 (2001).
  • [11] A. Martinez et al., Adv. Cryog. Eng. 51, 1384 (2006).
  • [12] F. Millet et al., AIP Conf. Proc. 823, 1837 (2006).
  • [13] S. Hamaguchi et al., IEEE Trans. Appl. Supercond. 20, 2051 (2010).
  • [14] S. Hamaguchi et al., Proceedings of the Twenty-Second International Cryogenic Engineering Conference and International Cryogenic Materials Conference 2008, 811 (2009).